Disables the loop protection warning messages displayed when configuring specific EAPS parameters.
This command has no arguments or variables.
By default, loop protection warnings are enabled and displayed when configuring specific EAPS parameters.
This is a global EAPS command. You configure the warning message display on a per switch basis, not per EAPS domain.
Adding EAPS primary or secondary ring ports to a VLAN
Deleting a protected VLAN
Disabling the global EAPS setting on the switch
Disabling an EAPS domain
Configuring an EAPS domain as a transit node
Unconfiguring EAPS primary or secondary ring ports from an EAPS domain
We recommend that you keep the loop protection warning messages enabled. If you have considerable knowledge and experience with EAPS, you might find the EAPS loop protection warning messages unnecessary. For example, if you use a script to configure your EAPS settings, disabling the warning messages allows you to configure EAPS without replying to each interactive yes/no question.
To confirm the setting on the switch, use the following command:
The following command disables the loop protection warning messages:
configure eaps config-warnings off
This command was first available in ExtremeXOS 11.4.
This command is available on all Universal switches supported in this document.